Explore plans

Frameless (European 32 mm) base cabinet carcass: two full-height gable sides, a bottom set between them, front and back top stretchers, a thin back panel (either housed in a rabbet/groove or nailed to the rear), optional adjustable shelves, an optional recessed toe-kick board and 0-2 overlay doors. Carcass is wood-decor melamine chipboard; the back is 3 mm HDF. Side and door grain runs vertically. All visible front edges are edge-banded.

Freestanding bookshelf in birch plywood: two full-height sides with a top and bottom set between them and a fixed number of fixed shelves. An optional thin back panel (nailed to the rear) stiffens the case, and an optional plinth/kick board lifts it off the floor. Side grain runs vertically; the top, bottom and shelf grain runs along their length. Visible front edges are banded.

Plywood drawer box sized to a cabinet opening for under- or side-mount runners. The box outer width is the opening less the per-side runner clearance. Joinery can be fronts captured between the sides (wide sides) or sides captured between the front and back. The bottom sits in a groove and is cut from its own thinner sheet. All part counts are multiplied by the number of drawers.

Four mitred frame pieces from one solid-wood moulding. The pieces are cut as a grain-continuity set (top, right side, bottom, left side) from the same board, in order, so the grain wraps around the frame. Lengths are long-point lengths.

Frameless wall cabinet: two full-height sides with a full top and bottom set between them, a thin back panel (rabbeted/grooved or nailed on), adjustable shelves, 0-2 overlay doors and an optional hanging rail for wall mounting. Carcass is wood-decor melamine chipboard, back is 3 mm HDF. Side and door grain runs vertically; visible front edges are banded.